EasyManuals Logo

Lexmark XM7355 User Manual

Lexmark XM7355
342 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #216 background imageLoading...
Page #216 background image
CAUTION—POTENTIAL INJURY: To avoid the risk of fire or electrical shock, use only the power cord
provided with this product or the manufacturer's authorized replacement.
CAUTION—POTENTIAL INJURY: When moving the printer, follow these guidelines to avoid personal
injury or printer damage:
Make sure that all doors and trays are closed.
Turn
o
the printer, and then unplug the power cord from the electrical outlet.
Disconnect all cords and cables from the printer.
If the printer has separate floor-standing optional trays or output options attached to it, then disconnect
them before moving the printer.
If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over
thresholds and breaks in flooring.
If the printer does not have a caster base but is configured with optional trays or output options, then remove
the output options and lift the printer o the trays. Do not try to lift the printer and any options at the same
time.
Always use the handholds on the printer to lift it.
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
Keep the printer in an upright position.
Avoid severe jarring movements.
Make sure that your fingers are not under the printer when you set it down.
Make sure that there is adequate clearance around the printer.
Note: Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to http://support.lexmark.com or contact customer support.
Saving energy and paper
Configuring
the power save mode settings
Sleep mode
1
From the home screen, touch Settings > Device > Power Management > Timeouts > Sleep Mode.
2 Specify the amount of time that the printer stays idle before it enters Sleep Mode.
Hibernate mode
1
From the home screen, touch Settings > Device > Power Management > Timeouts > Hibernate Timeout.
2 Select the amount of time that the printer stays idle before it enters Hibernate mode.
Maintaining the printer 216

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lexmark XM7355 and is the answer not in the manual?

Lexmark XM7355 Specifications

General IconGeneral
Print SpeedUp to 55 ppm
Scan TechnologyCIS
Standard ConnectivityUSB, Ethernet, Wi-Fi
Print Resolution1200 x 1200 dpi
Processor Speed1.2 GHz
Scanner TypeFlatbed, ADF
ADF Capacity150 sheets
Fax Speed33.6 kbps
FunctionsPrint, Copy, Scan, Fax
Copy SpeedUp to 55 cpm
Copy Resolution600 x 600 dpi
Scan ResolutionUp to 600 x 600 dpi
Mobile PrintingYes
Operating Systems SupportedWindows, Mac OS, Linux
Print TechnologyLaser
Maximum Monthly Duty Cycle300, 000 pages
Recommended Monthly Page VolumeUp to 50, 000 pages
Duplex PrintingYes
Maximum Input Capacity3, 300 sheets
Maximum Memory6 GB
Hard Disk320 GB
Paper Capacity650 sheets
Standard Memory2 GB

Related product manuals