155
3
3-3. Adjusting the seats
Before driving
smart entry & start system or wire-
less remote control.
The driving position will move to the
recorded position (not including the steer-
ing wheel and head-up display [if
equipped]).However, the seat will move to
a position slightly behind the recorded
position in order to make entering the vehi-
cle easier.
If the driving position is in a position that
has already been recorded, the seat and
outside rear view mirrors will not move.
2 Turn the engine switch to ACCES-
SORY mode or IGNITION ON
mode, or fasten a seat belt.
The seat, steering wheel and head-up dis-
play (if equipped) will move to the
recorded position.
■ Recalling the driving position using the
memory recall function
● Different driving positions can be regis-
tered for each electronic key. Therefore,
the driving position that is recalled may
be different depending on the key being
carried.
● If a door other than the driver’s door is
unlocked with the smart entry & start sys-
tem, the driving position cannot be
recalled. In this case, press the driving
position button which has been set.
■ Customization
The unlock door settings of the memory
recall function can be changed.
(Customizable features: P.482)
1 Up
Pull the head restraints up.
2 Down
Push the head restraint down while press-
ing the lock release button .
Head restraints
Head restraints are provided for all
seats.
■ Head restraint precautions
Observe the following precautions
regarding the head restraints. Failure to
do so may result in death or serious
injury.
● Use the head restraints designed for
each respective seat.
● Adjust the head restraints to the cor-
rect position at all times.
● After adjusting the head restraints,
push down on them and make sure
they are locked in position.
● Do not drive with the head restraints
removed.
Vertical adjustment
To Next Page
Loading...
