Lexus ES 200 - Page 168

167
3
3-5. Opening, closing the windows and moon roof
Before driving
oramic moon roof partway.
Closes the panoramic moon roof
Slide and hold the switch for-
ward. The panoramic moon roof will
fully close automatically.
■ The panoramic moon roof can be oper-
ated when
The engine switch is in IGNITION ON
mode.
■ Operating the panoramic moon roof
after turning the engine off
The panoramic moon roof and electronic
sunshade can be operated for approxi-
mately 45 seconds after the engine switch
is turned to ACCESSORY mode or turned
off. It cannot, however, be operated once
the driver’s door is opened.
■ Jam protection function
If an object is detected between the pan-
oramic moon roof and the frame in the fol-
lowing situations, travel is stopped and the
panoramic moon roof opens slightly:
● The panoramic moon roof is closing or
tilting down.
● The electronic sunshade is closing.
■ Door lock linked panoramic moon roof
operation
● The panoramic moon roof can be
opened and closed using the mechanical
key.
*
(P.458)
● The panoramic moon roof can be
opened and closed using the wireless
remote control.
*
(P.130)
*
: These settings must be customized at
your Lexus dealer.
■ Closing both the panoramic moon roof
and electronic sunshade
Slide the switch forward.
The electronic sunshade will close to the
half-open position and pause. The pan-
oramic moon roof will then fully close. Then
the electronic sunshade will fully close.
■ When the panoramic moon roof or elec-
tronic sunshade does not close normally
Perform the following procedure:
1 Stop the vehicle.
2 Turn the engine switch to IGNITION
ON mode.
3 Slide and hold the switch or
switch forward. Continue press-
ing the switch for approximately 10 sec-
onds after the panoramic moon roof or
electronic sunshade closes and
reopens. The panoramic moon roof and
electronic sunshade will start to close.
*
4 Check that the panoramic moon roof
and electronic sunshade are fully closed
and release the switch.
*
: If the switch is released at the incorrect
time, the procedure will have to be per-
formed again from the beginning.