253
4
4-5. Using the driving support systems
Driving
1 Pressing the cancel switch cancels
the speed control.
The speed control is also canceled when
the brake pedal is depressed.
2 Pressing the +RES switch resumes
the cruise control and returns vehi-
cle speed to the set speed.
However, cruise control does not resume
when the vehicle speed is approximately
25 km/h (16 mph) or less.
When your vehicle is too close to a
vehicle ahead, and sufficient automatic
deceleration via the cruise control is
not possible, the display will flash and
the buzzer will sound to alert the driver.
An example of this would be if another
driver cuts in front of you while you are
following a vehicle. Depress the brake
pedal to ensure an appropriate vehi-
cle-to-vehicle distance.
■ Warnings may not occur when
In the following instances, warnings
may not occur even when the vehicle-
to-vehicle distance is small.
When the speed of the preceding
vehicle matches or exceeds your
vehicle speed
When the preceding vehicle is trav-
eling at an extremely slow speed
Immediately after the cruise control
speed was set
When depressing the accelerator
pedal
When constant speed control mode is
selected, your vehicle will maintain a
set speed without controlling the vehi-
cle-to-vehicle distance. Select this
mode only when vehicle-to-vehicle dis-
tance control mode does not function
Distance options
Vehicle-to-vehicle
distance
Long
Approximately 50
m (160 ft.)
Medium
Approximately 40
m (130 ft.)
Short
Approximately 30
m (100 ft.)
Canceling and resuming the
speed control
Approach warning (vehicle-to-
vehicle distance control mode)
Selecting constant speed con-
trol mode
To Next Page
