Editing contact data
Transferring contact data
Up to 5
,000 contacts can be registered for each connected cellular phone. Only
the contacts corresponding to the connected cellular phone can be displayed. In
the contacts, up to 4 phone numbers can be registered for each contact. Contacts
are managed for each connected phone.
This function can be used with cellular phones that support automatic contact data
transfer (PBAP). Refer to the included instruction manual or compatible profiles
for the connected cellular phone, to determine whether it supports automatic
contact data transfer (PBAP).
To transfer contacts with automatic contact data transfer (PBAP), [Sync contacts]
must be set to on in the Bluetooth
®
settings.
INFORMATION
● When tr
ansferring contact data, each data is subject to the following restrictions.
• When five or more phone numbers are registered to a single contact, all phone
numbers will be registered to the multimedia system as multiple contacts with the
same name.
• The name is transferred at the same time as the phone number. Depending on
the model, some letters, such as symbols, or all letters may not be transferred.
Furthermore, even if they are transferred they may not be displayed correctly.
• Typically, secret memory is not read. (It is possible in some cases, depending on
cellular phone specifications)
• The group names registered to the cellular phone are not transferred.
• The phone number type shown in contacts on the multimedia system is automati-
cally assigned based on information from the source device. However, depending
on the model of cellular phone and usage environment, the icons may all be
identical.
• Depending on the model of cellular phone, the cellular phone’s pin number and
an authentication password may need to be entered when transferring contact
data. For details, refer to the included instruction manual for the connected cellular
phone.
● Models of cellular phone that support batch transfer have the following characteristics
when transferring contact data.
• Transfer may take as long as 10 minutes.
• Even if the contact list transfer screen is being displayed, it is possible to switch to
another screen. In this case, contact list transfer will continue.
● If the engine switch is turned off during contact list transfer, the transfer will be
canceled. In this case, start the engine and carry out transfer operations again.
6-7. Editing contact data
200
To Next Page
Loading...
