271
4-5. Using the driving support systems
4
Driving
preceding vehicle starts off, pressing the “RES” switch or depressing the accelera-
tor pedal will resume follow-up cruising (start off operation). If a start off operation
is not performed, the controlled stop will continue.
Vehicles with Traffic Jam Assist: While driving on a highway or expressway, if a
preceding vehicle stops, your vehicle will stop accordingly. On some highways and
expressways, if the system determines that the preceding vehicle starts off within
approximately 3 minutes of stopping, a buzzer will sound and a message will be
displayed on the multi-information display to notify the driver, and your vehicle will
start off accordingly following the preceding vehicle. (Extended resume time)
■ Meter display
Multi-information display
Set vehicle speed
Indicators
■ Switches
Driving assist mode select switch
Driving assist switch
“+” switch/“RES” switch
“-” switch
Cancel switch
Vehicle-to-vehicle distance switch
■ Setting the vehicle speed
1 Press the driving assist mode select
switch to select Adaptive Cruise
Mode.
The dynamic radar cruise control indicator
will illuminate.
2 Using the accelerator pedal, accel-
erate or decelerate to the desired
vehicle speed (approximately 20
mph [30 km/h] or more), and press
the driving assist switch to set the
set vehicle speed.
The set vehicle speed will be displayed on
System components
A
B
C
A
B
C
Using the dynamic radar cruise
control
D
E
F
To Next Page
Loading...
