279
4-5. Using the driving support systems
4
Driving
The cruise control indicator will illuminate.
2 Using the accelerator pedal, accel-
erate to the desired vehicle speed
(approximately 20 mph [30 km/h]
or more), and press the driving
assist switch to set the set vehicle
speed.
The vehicle speed at the moment the
switch is released will be the set vehicle
speed.
■ Adjusting the set vehicle speed
Adjusting the set vehicle speed
using the switches
To change the set vehicle speed, press the
“+” or “-” switch until the desired speed is
displayed.
1 Increase set vehicle speed
2 Decrease set vehicle speed
The set vehicle speed will increase or
decrease as follows:
Fine adjustment: By 1 mph (1.6 km/h) or 1
km/h (0.6 mph) each time the switch is
pressed
Large adjustment: Increases continuously
while the switch is pressed and held
Increasing the set vehicle speed
using the accelerator pedal
1 Depress the accelerator pedal to
accelerate the vehicle to the
desired vehicle speed.
2 Press the “+” switch.
■ Canceling/resuming control
1 Press the cancel switch or driving
assist switch to cancel control.
Control will also be canceled if the brake
pedal is depressed.
2 Press the “RES” switch to resume
control.
To Next Page
Loading...
