113
3-3. Adjusting the seats
3
Before driving
When any of the following has been
performed, the driver’s seat and steer-
ing wheel automatically return to their
original positions.
The engine switch has been turned
to ACC or ON.
The driver’s seat belt has been fas-
tened.
■ Operation of the power easy access
system
● When exiting the vehicle, the power easy
access system may not operate if the seat
is already close to the rearmost position,
etc.
● If the seat position is adjusted during the
power easy access system operation, the
automatic operating will stop. (The seat
will change to manual operation.)
● If the seat position is adjusted during or
after the power easy access system oper-
ation when the driver is exiting the vehi-
cle, the power easy access system will not
operate when entering the vehicle.
■ Customization
The seat movement amount settings of the
power easy access system can be custom-
ized.
(Customizable features: P.367)
1 Turn the engine switch to ON.
2
Check that the shift position is in P.
3
Adjust the driver’s seat, steering
wheel, outside rear view mirrors
and head-up display to the desired
positions.
4
While pressing the “SET” button, or
within 3 seconds after the “SET”
button is pressed, press button “1”,
“2” or “3” until the buzzer sounds.
If the selected button has already been
preset, the previously recorded position
will be overwritten.
■ Seat positions that can be memorized
(P.110)
The adjusted positions other than the posi-
tion adjusted by lumbar support switch can
be recorded.
■ In order to correctly use the driving
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
Recording a driving position into
memory
WARNING
■ Seat adjustment caution
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
To Next Page
Loading...
