EasyManua.ls Logo

Lexus LC500 - To Avoid Malfunction of the Front Camera

Lexus LC500
410 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
174
4-5. Using the driving support systems
WARNING
Do not attach accessories, stickers
(including transparent stickers) or
other items to the radar sensor, radar
sensor cover or surrounding area.
Do not subject the radar sensor or its
surrounding area to a strong impact.
If the radar sensor, front grille, or front
bumper has been subjected to a
strong impact, have the vehicle
inspected by your Lexus dealer.
Do not disassemble the radar sensor.
Do not modify or paint the radar sen-
sor or radar sensor cover.
In the following cases, the radar sensor
must be recalibrated. Contact your
Lexus dealer for details.
When the radar sensor or front grille
are removed and installed, or replaced
When the front bumper is replaced
To avoid malfunction of the front
camera
Observe the following precautions.
Otherwise, the front camera may not
operate properly, possibly leading to an
accident resulting in death or serious
injury.
Keep the windshield clean at all times.
If the windshield is dirty or covered
with an oily film, water droplets, snow,
etc., clean the windshield.
If a glass coating agent is applied to the
windshield, it will still be necessary to
use the windshield wipers to remove
water droplets, etc. from the area of
the windshield in front of the front
camera.
If the inner side of the windshield
where the front camera is installed is
dirty, contact your Lexus dealer.
Do not attach objects, such as stickers,
transparent stickers, etc., to the outer
side of the windshield in front of the
front camera (shaded area in the illus-
tration).
From the top of the windshield to
approximately 0.4 in. (1 cm) below
the bottom of the front camera
Approximately 7.9 in. (20 cm)
(Approximately 4.0 in. [10 cm] to the
right and left from the center of the
front camera)
If the part of the windshield in front of
the front camera is fogged up or cov-
ered with condensation, or ice, use the
windshield defogger to remove the
fog, condensation, or ice. (P.233)
If water droplets cannot be properly
removed from the area of the wind-
shield in front of the front camera by
the windshield wipers, replace the
wiper insert or wiper blade.
Do not attach window tint to the wind-
shield.
Replace the windshield if it is damaged
or cracked.
After replacing the windshield, the
front camera must be recalibrated.
Contact your Lexus dealer for details.
Do not allow liquids to contact the
front camera.
Do not allow bright lights to shine into
the front camera.
A
B

Table of Contents

Related product manuals