Lexus LC500 - Before Programming; Reprogramming a Single Homelink Button

254
5-6. Using the other interior features
opener motor recognizes the
HomeLink
®
signal.
■ Enabling 2-way communication
with a garage door (only available
for compatible devices)
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
if the garage door opener motor used
is a compatible device. (To check
device compatibility, refer to
www.homelink.com.)
1 Within 5 seconds after program-
ming the garage door opener has
been completed, if the garage door
opener motor is trained to
HomeLink
®
, both garage door
operation indicators will flash rap-
idly (green) and the light on the
garage door opener motor will
blink twice, indicating that 2-way
communication is enabled.
If the indicators do not flash, perform 2 and
3 within the first 10 presses of the
HomeLink
®
button after programming
has been completed.
2 Press a programmed HomeLink
®
button to operate a garage door.
3 Within 1 minute of pressing the
HomeLink
®
button, after the
garage door operation has
stopped, press the “Learn” or
“Smart” button on the garage door
opener motor. Within 5 seconds of
the establishment of 2-way com-
munication with the garage door
opener, both garage door opera-
tion indicators in the vehicle will
flash rapidly (green) and the light
on the garage door opener motor
will blink twice, indicating that 2-
way communication is enabled.
■ Reprogramming a single
HomeLink
®
button
When the following procedure is per-
formed, buttons which already have
devices registered to them can be
overwritten:
1 With one hand, press and hold the
desired HomeLink
®
button.
2 When the HomeLink
®
indicator
starts flashing (orange), continue to
hold the HomeLink
®
button and
perform “Programming
HomeLink
®
” 1 (it takes 20 sec-
onds for the HomeLink
®
indicator
to start flashing).
■ Before programming
● Install a new battery in the transmitter.
● The battery side of the transmitter must
be pointed away from the HomeLink
®
.