181
4-5. Using the driving support systems
4
Driving
■ Enabling/disabling the pre-colli-
sion system
The pre-collision system can be
enabled/disabled on (P.79) of
the multi-information display.
The system is automatically enabled each
time the engine switch is turned to ON.
If the system is disabled, the PCS warn-
ing light will turn on and a message will
be displayed on the multi-information
display.
■ Changing the pre-collision warn-
ing timing
The pre-collision warning timing can
be changed on (P.79) of the
multi-information display.
The operation timing setting is retained
when the engine switch is turned off.
1 Far
The warning will begin to operate earlier
than with the default timing.
2 Middle
This is the default setting.
3 Near
The warning will begin to operate later
than with the default timing.
■ Operational conditions
The pre-collision system is enabled and the
WARNING
● If the vehicle cannot be driven in a sta-
ble manner, such as when the vehicle
has been in an accident or is malfunc-
tioning
● When the vehicle is driven in a sporty
manner or off-road
● When the tires are not properly
inflated
● When the tires are very worn
● When tires of a size other than speci-
fied are installed
● When tire chains are installed
● When a compact spare tire or an
emergency tire puncture repair kit is
used
● If equipment (snow plow, etc.) that
may obstruct the radar sensor or front
camera is temporarily installed to the
vehicle
Changing settings of the pre-
collision system
To Next Page
