CHASSIS
239
CHECKING BRAKE FLUID
63L001−2
To check the fluid level, simply look at the see−through reservoir.
The level should be between the ”MAX” and ”MIN” lines on the
tank.
It is normal for the brake fluid level to go down slightly as the brake
pads wear. So be sure to keep the reservoir filled.
If the reservoir needs frequent refilling, it may indicate a serious
mechanical problem.
If the level is low, add FMVSS No.116 DOT 3 or SAE J1703 brake
fluid to the brake reservoir.
Remove and replace the reservoir cover by hand. Add brake fluid
up to the ”MAX” line.
Use only newly opened brake fluid. Once opened, brake fluid
absorbs moisture from the air, and excess moisture can cause a
dangerous loss of braking efficiency.
CAUTION
Take care when filling the reservoir because brake fluid can
harm your eyes and damage painted surfaces. If fluid gets in
your eyes, flush your eyes with clean water.
To Next Page
Loading...
