Programming an entrance gate/Programming all devices
in the Canadian market
1. Decide which of the 3 HomeLink
buttons you want to
program.
2. Place your hand–held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
.
Keep the indicator light on the HomeLink
in view while
programming.
3. Press and hold the selected HomeLink
button.
4. Continuously press and release (cycle) the hand–held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
changes from
a slow to a rapid flash after 20 seconds, you can release both
buttons.
6. Test the operation of the HomeLink
by pressing the
newly programmed button. Check to see if the gate/device
operates correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
button to program another device.
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
dealer for assistance.
Reprogramming a button
Individual HomeLink
buttons cannot be erased, however,
to reprogram a single button, follow the procedure
“Programming the HomeLink
”.
(b) Operating the HomeLink
To operate the HomeLink
, press the appropriate
HomeLink
button to activate the programmed device. The
HomeLink
indicator light should come on. The
HomeLink
continues to send the signal for up to 20
seconds as long as the button is pressed.
(c) Erasing the entire HomeLink
memory
(all three programs)
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
in the HomeLink
memory.
CAUTION
When programming the HomeLink
Universal
Transceiver, you may be operating a garage door or
other device. Make sure people and objects are out
of the way of the garage door or other device to
prevent potential harm or damage.
To Next Page
Loading...
