Operation
3.8 Shutdown of the
TURBOTRONIK
Press the STOP key, and wait until the pump comes to a
standstill.
The LEDs in the keys START, STOP and NORMAL are
extinguished.
Switch the POWER switch to the “0” position. The tem-
perature control at the TURBOTRONIK NT 340 MA and
NT 341 MA with temperature control is switched off.
If the red LED DON’T DISCONNECT has gone off the
connection lines to the TURBOVAC can be disconnected
in case of necessity.
Caution
Only after the pump has come to a standstill
is the POWER switch to be switched to the
“0” positon.
In case of accidental shutdown, start up the pump at
once.
3.9 Maintenance
The TURBOTRONIK is maintenance-free.
20
GA 05.218/3.02 - 11/97
To Next Page
Loading...
