16
22 SWITCH READING DISPLAY FOR THE OUTDOOR
TEMPERATURE/HUMIDITY SENSORS
• Mounting under an eave or deck rail works well.
• Mount the remote sensor on the North side where to prevent sun from
causing incorrect readings
• Be sure the outdoor sensor is mounted vertically to drain moisture.
• Mount at least 6 feet in the air for a strong RF (radio frequency) signal.
• To prevent wireless interference, place units at least 3 ft (0.9 m) away from
electronic devices (TV, computer, microwave, radio, etc.)
• To maximize atomic signal reception, place the weather station away from large
metallic items, thick walls, metal surfaces, or other objects that may limit
radio communication.
• The maximum wireless transmission range must be within 300 feet (100m)
in open air, not including walls and floors.
• In Normal display, press and release to interchange the reading display
for the outdoor temperature/humidity sensors.
• There are CH1, CH2 CH3 or cycle display.
• In cycle display mode, the outdoor temperature/humidity reading will be
switched every 3s.
23 IMPORTANT PLACEMENT GUIDELINES
24 CARE AND MAINTENANCE
• Do not mix old and new batteries.
• Do not mix Alkaline, Standard, Lithium, or Rechargeable batteries.
• Always purchase the correct size and grade of battery most suitable for intended
use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure the batteries are installed with correct polarity (+ and -).
• Remove batteries from equipment which is not to be used for an extended period
of time.
• Promptly remove expired batteries.
To Next Page
Loading...
