LG-Ericsson iPECS eMG80 - Call Profile Routing

iPECS eMG80/100& eMG800 & UCP & vUCP
Feature Description and Operation Manual Issue 2.4
431
5.6 Call Profile Routing
Description
Call Profile Routing is an extension of the Station ICR feature. You can configure and assign up to ten (10)
scenarios to each of the three (3) Call Profiles. Then you can activate a Call Profile to route your calls.
The system will attempt to route your incoming calls to the first destination that meets the scenario. If the
destination does not answer in the Profile Timer, the call routes to the next destination.
Operation
iPECS IP & LDP Phones
To create a Call Profile Scenario
1) Press the [TRANS/PGM] button and dial “24”, the ICR menu code.
Or Log in to the Station Web Portal.
2) Select the desired Scenario number (0 - 9).
3) Select the type of Caller ID (0 – 5):
4) Type 0 – Station CID
5) Type 1 - All Station
6) Type 2 – CO CID
7) Type 3 - All CO call
8) Type 4 - All call
9) Type 5 - N/A
10) Enter the Scenario Start and End Date (YYMMDD).
11) Select day-of-week using Flex button:
12) Flex button 1 (MON) – Flex button 7 (SUN)
13) Flex 8 button (Holiday)
14) Enter scenario Start Time and End time (HHMM).
15) Select Type of destination (0 – 6):
16) Type 0 – Station
17) Type 1 - Hunt group
18) Type 2 - CO Line Number
19) Type 3 - CO Group number
20) Type 4 - CO Loop
21) Type 5 - CO Transit
22) Type 6 - N/A
23) Select Scenario Priority (0 to 9) (0:highest priority).
24) Select Forward from Net call (0/1).
25) Select Call Profile Table Index (0-3) (0: not use CP).
26) Select Call Profile Timer (00–60 seconds).
27) Select Call Profile Apply Option: All call, Direct call (except CCR, DISA)