LG 19LC2D - Page 77

23. Channel Add/Del (Command: m b)
To add and delete the channels.
Transmission [m] [b] [ ] [Set ID] [] [Data] [Cr]
Data 0: Channel Delete Data 1: Channel Add
Acknowledgement[b] [ ] [Set ID] [ ] [OK/NG] [Data] [x]
24.
Key (Command: m c)
To send IR remote key code.
Transmission [m] [c][ ] [Set ID][ ] [Data] [Cr]
Acknowledgement [c] [][set ID] [] [OK/NG] [Data] [x]
the ATSC tuner automatically maps the channel to the
Major number, the Physical number is not required when
sending a command.
Data 0: Physical Channel Number
NTSC air: 02-45, NTSC cable: 01,0E-7D
ATSC air: 01-45, ATSC cable: 01-87
Data1 & 2: Major Channel Number
Data1: High byte Data2: Low byte
Two bytes are available for the Major and Minor, nor-
mally only the second byte is used.
Data3 & 4: Minor Channel Number
Not needed for NTSC.
OF TV 39 CC
0B INPUT 40 •
08 POWER 41 •
0E TIMER 07 _l
10-19 Number Key 0-9 06 •
4C - (Dash) 44 ENTER
1A ADJUST 43 MENU
09 MUTE 52 SOUND
02 VOL + 4D PICTURE
03 VOL - 5B EXIT
00 CH + 0A SAP
01 CH - CB BACK
1E FAV
25. Back Light (Command: m g)
To adjust screen back light.
Transmission [m] [g][ ][Set ID][ ][Data] [Cr]
Data Min: 0 4 Max: 64 (*transmit by Hexadecimal Code)
*Refer to 'Real data mapping 1'. _ p.5.
Acknowledgement [g] [] [Set ID] [] [OK/NG] [Data] [x]
26.
Channel Tuning (Command: m a)
To tune channel to following physical/major/minor number.
Transmission [rn] [a][] [Set ID][] [DataO] [ ] [Data! ]
[ ] [Data2] [ ] [Data3] [ ] [Data4] [ ] [DataS] [Cr]
Digital channels have a Physical, Major, and Minor channel
number. The Physical number is the actual digital channel
number, the Major is the number that the channel should
be mapped to, and the Minor is the sub-channel. Since
76