6
ENG
ENGLISH
INSTALLATION MENU
PUBLIC DISPLAY SETUP
Refer to the PDM menu options as described
below and on the following page. Then set the
options to your requirements.
1
Use the v or
^
or < or > button to select
desired menu option.
2
Use the
OK
button to return to previous menu.
3
Use the
OK
button to exit menu.
Installation Menu (V 2.6)
Public Display Settings
TV Link-Loader
Password Change
Set ID Setup
Configuration Setup
Pro:Centric
OK
Public Display Mode Menu Items
Public Display Settings
ꔊ
Yes
ꔋ
Yes
TV
Virtual
12
2
No
AV1
Enable
0
100
No
15
No
7
0
0
0
OK
• Public Display Mode
• Power On Defult
• Input Source
• Tune Mode
• Major
• Minor
• Aux Source Setting
• Input Source
• Setting
• Minimum Volume
• Maximum Volume
• Start Volume
• Level
•
Power Management
• Setting
• Key Management
• Factory Reset
• Aspect Ratio
Previous
ꕣ
Public Display Mode
If ‘Public Display Mode’ is set to Yes (Enabled), all
functions of the Public Display Settings are active.
If ‘Public Display Mode’ is set to No (Disabled), all
functions of the Public Display mode are not active.
Power On Default
This function allows you to determine the initial channel
number and external input when the TV is turned
On. This feature is useful for an in-house information
Accessing the Public Display Mode
Menu
1
Use the
v
or
^
button to select the Public
Display Settings option and press the
OK
button.
2
Once in the Public Display Settings menu,
use the
v
^
< > button to select and adjust
the menu options to your requirements. If you
want Public Display mode to be enabled, select
‘Yes’ for that option.
Installation Menu (V 2.6)
Public Display Settings
TV Link-Loader
Password Change
Set ID Setup
Configuration Setup
Pro:Centric
OK
Accessing the Public Display Mode
Menu by pressing and holding
down ENTER Button* on the TLL-
1100A Cloner
1
Press and hold the ENTER button for more that
5 seconds. The TV will automatically display
the Installation Menu after about 5-7 seconds.
* The TLL-1100A TV Link-Loader is not supplied
with this TV.