x= 0.315 ± 0.005 , y= 0.331±0.005 in 5~30 minutes.
x=0.313 ± 0.005, y=0.329±0.005 over than 30minutes, and confirm.
(Option) It’s another method for 6500K color adjustment at Gumi & NT
At first, check ∆UV. If that is under 0.0065, the set is not adjusted.
If not. It is adjust to meet u’= 0.198±0.0065, v’=0.469±0.0065
Adjust to meet Y = over 180 cd and confirm.
* Input Full White Pattern (Video level : 700 mVp-p)
* Set as 6500K by commanding COLOR_MODE_CHANGE Command code.
* 6500K color adjustment
* Input Gamma calibration Pattern (R,G,B, Grey 20 )
This model must be calibrated Gamma2.2
Gamma calibration and verify
If this TCO 0.3 spec should be satisfied later, refer to below method.
.
(Option) It’s another method for 6500K color adjustment at Gumi & NT
At first, check ∆UV. If that is under 0.0065, the set is not adjusted.
If not. It is adjust to meet u’= 0.198±0.0065, v’=0.469±0.0065
Adjust to meet Y = over 200 cd and confirm.
If this TCO 0.6 spec should be satisfied later, refer to below method.
2min 5min 10min 20min 30min
X 0.316 0.315 0.313 0.313 0.313
Y 0.334 0.333 0.329 0.329 0.329
Adjust to meet Y = over 200 cd and confirm.
3.2.4.5. Confirm User color coordinates .
* Confirm Whether User color is saved same as 6500K.
* After confirming Color coordinates, Must return to 6500K
* Confirm whether user color is 50. If the value of user color(R/G/B) is 30, do adjust again by
4. Total Assembly line process
- 11 - Copyright © 2018 LG Electronics Inc. All rights reserved.
Only training and service purposes
To Next Page
Loading...
