10
ENG
ENGLISH
ASSEMBLING AND PREPARING
Detaching the Stand Base
Screw Cover
Stand Body
Stand Base
y
To protect the screen from scratches, cover the
surface with a soft cloth.
CAUTION
2
1
3
Turn the screw to the left.
Pull out the Stand Base.
Place the screen face down
As shown in the illustration, pull Screw Cover out to
separate it from the set.
4
Remove the two screws on the back of stand body.
As shown in the illustration, disconnect the stand
body from the stand hinge.
1
2
y
Illustrations in this document represent typical
procedures, so they may look different from the
actual product.
y
Applying excessive force when tightening screws
may cause damage to the monitor. Damage
caused in this way will not be covered by the
product warranty.
y
Be careful not to hurt your hand on the edges of
the screw covers.
y
Do not carry the monitor upside down by just
holding the base. This may cause the monitor
to fall off the stand and could result in personal
injury.
y
When lifting or moving the monitor, do not touch
the monitor screen. The force applied to the moni-
tor screen may cause damage to it.
CAUTION
It may hurt your foot off the stand, so be careful.
CAUTION
To Next Page
Loading...
