LG 32LY760H - Lifting and Moving the TV; Setting up the TV

12
206-4259
Note: After it is turned ON, the TV begins an initialization process, and it may take several minutes
for the EZ-Manager Wizard to appear.
The primary purpose of the EZ-Manager Wizard is to guide you through the process (automated or
manual) of configuring the essential Installer Menu items for Pro:Centric operation. The wizard will
appear on the screen each time the TV is turned ON, until one of its configuration methods has
been completed or the wizard is exited. Use the Installer Remote to make selections and complete
each wizard step.
While the EZ-Manager Wizard is intended primarily for Pro:Centric-related conguration, the
wizard also offers Zoning as well as USB conguration options.
• LY760H TVs support the TV Zoning and Wi-Fi Zoning features, both of which enable location-
specic settings (see Reference section, “Using the TV’s Zoning Features,” for further information).
The EZ-Manager Wizard enables you to set the TV Zone # and/or the Wi-Fi Zone # in the TV as
part of the conguration process.
• The EZ-Manager Wizard also enables you to access USB download options as part of the
conguration process, if desired, to perform USB conguration and/or update functions.
Caution: Do NOT unplug the TV power cord or remove the antenna cable or, if
applicable, the LAN cable during the conguration process, as doing so will interrupt
the current step and may corrupt the conguration data.
Before You Begin
• If you plan to create a Master TV Setup using the procedure described on pages 36 to 38, be sure
to exit the EZ-Manager Wizard in order to avoid setting modes that may restrict the custom setup
procedure. See also “Initiate Conguration or Exit the EZ-Manager Wizard” on the following page.
• If it has been completed or exited and therefore does not display, the EZ-Manager Wizard can
be reactivated; however, this requires that you restore the TV to a factory default condition. See
Reference section, “Restoring Factory Defaults on the TV(s),” for further information.
• Each wizard step is allotted a time frame after which the wizard proceeds without user interaction.
If the Pro:Centric server is congured on the system and if no location-specic settings are
required in the TV, for example, TV Zone, Wi-Fi Zone, Label, and/or Room Number settings,
you can simply turn ON the TV, and once initiated, the wizard will proceed through each of the
conguration steps with no further user interaction.
• If any of the conguration steps fails, you will see a “Diagnostics” screen with an indication of the
failure. You will then have the opportunity to reinitiate the conguration process from the previous
screen or exit the EZ-Manager Wizard.
• If you would like to enable the SoftAP Media Share feature on a TV that will eventually be
congured for FTG Mode, you will need to use the IP Environment Menu to specify the feature
settings before the TV is congured for FTG Mode. Refer to “IP Environment Setup” on pages
51 to 58 for information on the IP Environment Menu. See also “Custom Master TV Setup” on
pages 36 to 38.
EZ-Manager Wizard