LG 32LY760H - Cloning Procedures

44
206-4259
Cloning Procedures (Cont.)
(Continued from previous page)
9. When you are ready to initiate the Teaching process, select UPDATE on the screen and then
press OK on the Installer Remote.
CANCEL
BACK
UPDATE
Channel Tuning / Channel Banner Display
Logical
Physical
TEACH TO TV (TLX)
TV MANAGER
Select USB Memory Device
ˇ
USB Device 1: Device Name
Select the file to download, and then select UPDATE below.
xxLY760H-UA00001.TLX
Teaching status will be shown in a pop-up progress banner at the bottom of the Teach To TV
(TLX) screen. This process may take a few minutes. Do NOT remove the USB device while
Teaching is in progress. When the Teaching process is complete, an “Updating completed”
message will briey be displayed, and then, the TV will reboot. *
10. Remove the USB memory device from the Target TV, and verify that the appropriate
conguration is now resident on the Target TV.
Note: If the Target TV was previously in Pass-through Mode, and the TLX le used for Teaching
contained an FTG Channel Map, the Target TV CPU is now in FTG Mode. Upon restart, the TV
tunes according to the Start Channel setting in the Installer Menu. If a Start Channel is specied,
the TV will tune to that channel, though, in the case of FTG Mode conguration, a channel banner
will only be displayed if the Start Channel is included in the FTG Channel Map (depending on your
selection in step 8, the channel banner will display either the Start Channel’s logical channel number
or physical RF channel number). Otherwise, the TV will either return to the last channel tuned (TV in
Pass-through Mode) or tune to the rst channel in the FTG Channel Map (TV in FTG Mode). If the
latter, remember that the channels in the FTG Channel Map are always arranged in logical order,
regardless of your selection in step 8.
* LY760H TVs with CPU software earlier than v3.02.32 will not reboot upon completion of the Teaching process.