59
206-4259
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 1). See Installer Menu detailed descriptions for further information.
093 RJP AVAILABLE 001
TV Connections
Caution: Make these connections ONLY after Master TV Setup and TV cloning procedures
are complete. Also, make sure to use the RJ-45 Control cable from the RJP cable bundle to
make the connection to the TV’s RJP port. Do NOT connect a standard Ethernet cable to
the RJP port, as this may damage the TV and network equipment.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
port on the TV’s rear jack panel. Then, connect HDMI and Composite Video/Audio connectors, as
applicable, for the cable bundle.
Reference: Remote Jack Pack / TV Connections & Setup
SPEAKER OUT
LINE OUT
PTC SERVICE
(SERVICE ONLY)
RJP
RESET
MPI
RS-232C IN
(CONTROL & SERVICE)
L/MONO AUDIO R
COMPONENT IN / AV IN
ANTENNA /
CABLE IN
LAN
AUX LAN
OPTICAL
DIGITAL
AUDIO OUT
IN
1
USB IN 1
UPDATE
VIDEO/
Y
P
B
P
R
PC AUDIO
HDMI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP
Connect RJ-45 Control
cable from RJP cable
bundle.
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
Note: RGB is not supported on these TV models. If an RGB source is connected to a legacy
RJP, you will see a brief message on-screen to indicate that this device is not supported.
To Next Page
Loading...
