19
CONNECTIONS & SETUP
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of
the screen may remain visible on the screen.
VCR SETUP
1. When connecting with an antenna
VIDEO
AUDIO
( )
VIDEO
AUDIO
COMPONENT IN
S-VIDEO
AV IN 3
VARIABLE
AUDIO OUT
S-VIDEO
OUT
IN
(R) AUDIO (L) VIDEO
34
OUTPUT
SWITCH
ANT OUT
ANT IN
ANTENNA
IN
ANTENNA
OUT
VIDEO
AUDIO
( )
VIDEO
AUDIO
COMPONENT IN
S-VIDEO
AV IN 3
VARIABLE
AUDIO OUT
Connect the RF out socket of the VCR to the
Antenna socket on the set.
Connect the antenna cable to the RF antenna
socket of the VCR.
Press the PLAY button on the VCR and match
the appropriate programme between the TV
and VCR for viewing.
VCR
2. When connecting with a RCA cable
VIDEO
AUDIO
MONO
( )
VIDEOVIDEO
AUDIO
COMPONENT IN
S-VIDEO
AV IN 3V IN 3
VARIABLE
AUDIO OUT
S-VIDEO
OUT
IN
(R) AUDIO (L) VIDEO
34
OUTPUT
SWITCH
ANT OUT
ANT IN
ANTENNA
IN
ANTENNA
OUT
VIDEO
AUDIO
( )
VIDEO
AUDIO
COMPONENT IN
S-VIDEO
AV IN 3
VARIABLE
AUDIO OUT
VCR
Connect the AUDIO/VIDEO jacks between TV
and VCR. Match the jack colors (Video = yel-
low, Audio Left = white, and Audio Right = red)
Insert a video tape into the VCR and press
PLAY on the VCR. (Refer to the VCR owner’s
manual.)
Select AV3 input source using the INPUT but-
ton on the remote control.
- If connected to AV IN4, select AV4 input
source.
1
2
3
1
2
3
NOTE
GG
If you have a mono VCR, connect the audio cable from the VCR to the
AAUUDDIIOO LL//MMOONNOO
jack of the set.
Back panel of the set
Back panel of the set
1
1
U0585Ben_01 12/6/06 11:05 AM Page 19
To Next Page
Loading...
