LG 37LC2D Series - HDSTB Setup

24
CONNECTIONS & SETUP
1. When connecting with a D-sub 15 pin cable
Connect the RGB output of the digital set-top
box to the RGB (PC/DTV) jack on the set.
Connect the audio outputs of the set-top box
to the AUDIO (RGB/DVI) jack on the set.
Turn on the digital set-top box. (Refer to the
owner’s manual for the digital set-top box.)
Select RGB input source with using the INPUT
button on the remote control.
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if
you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as
shown below.
(R) AUDIO (L)
RGB-DTV OUTPUT
VIDEO AUDIO
( )
VIDEO
AUDIO
COMPONENT IN
S-VIDEO
AV IN 3
VARIABLE
AUDIO OUT
RGB (PC / DTV)
RGB IN
AUDIO (RGB/DVI) IN
OUT
REMOTE
CONTROL
ANTENNA
IN
ANTENNA
OUT
RGB (PC / DTV)
RGB IN
AUDIO (RGB/DVI) IN
OUT
REMOTE
CONTROL
HDMI IN
DIGITAL AUDIO
OUT
OPTICAL
1(DVI)
2
RS-232C IN
(CONTROL & SERVICE)
HDMI IN
DIGITAL AUDIO
OUT
OPTICAL
1(DVI)
2
RS-232C IN
(CONTROL & SERVICE)
Digital Set-top Box
HDSTB SETUP
2. When connecting with a HDMI cable
Connect the HDMI output of the digital set-top
box to the HDMI IN (or HDMI/DVI IN) jack on
the set.
Select HDMI/DVI (or HDMI1/DVI or HDMI2)
input source with using the INPUT button on
the remote control.
Turn on the digital set-top box. (Refer to the
owner’s manual for the digital set-top box.)
Digital Set-top Box
HDMI-DTV OUTPUT
VIDEO AUDIO
( )
VIDEO
AUDIO
COMPONENT IN
S-VIDEO
AV IN 3
VARIABLE
AUDIO OUT
RGB (PC / DTV)
RGB IN
AUDIO (RGB/DVI) IN
OUT
REMOTE
CONTROL
ANTENNA
IN
ANTENNA
OUT
RGB (PC / DTV)
RGB IN
AUDIO (RGB/DVI) IN
OUT
REMOTE
CONTROL
HDMI IN
DIGITAL AUDIO
OUT
OPTICAL
1(DVI)
2
RS-232C IN
(CONTROL & SERVICE)VICE)
HDMI IN
DIGITAL AUDIO
OUT
OPTICAL
1(DVI)
2
RS-232C IN
(CONTROL & SERVICE)
1
2
3
4
1
2
3
NOTE
!
GG
TV can receive the video and audio signal simultaneously with using a HDMI cable.
GG
If the digital set-top box supports Auto HDMI function, output resolution of the digital set-top box will
be automatically set to 1280x720p.
GG
If the digital set-top box does not support Auto HDMI, you need to set the output resolution appropriate-
ly. To get the best picture quality, adjust the output resolution of the digital set-top box to 1280x720p.
CONNECTIONS & SETUP
Back panel of the set
Back panel of the set
12
1
U0585Ben_01 12/6/06 11:05 AM Page 24