SPECIAL FUNCTIONS
33
Input Source Selection for Sub Picture
Press the PIP INPUT button to select the input source for the sub picture.
Each press of PIP INPUT button is pressed, each input source for the sub picture is displayed.
In some models, when the sub picture quality get poor for sub picture, select Auto, PAL, SECAM or
NTSC in PIP System menu.
Sub Picture Size Adjustment
Moving the Sub Picture (PIP mode only)
Win. position
DD
FF GG
EE
NOTE
GG
You can’t select the same modes for main picture and sub picture simultaneously.
GG
When the main picture is DTV or HDMI mode, the sub picture isn’t available to select DTV and HDMI
modes.
GG
When the main picture is RGB mode, the sub picture isn’t available to select HDMI modes.
GG
When the main picture is HDMI mode, the sub picture isn’t available to select RGB modes.
GG
It’s not available to use this function in Vertical Frequency 85Hz for sub picture.
GG
It’s not available to use 1280x720, 60Hz in HDMI[PC] for sub picture.
Press the SIZE button and then
F
or
G
button to adjust the sub
picture size.
With SIZE button in DW1 modes, main and sub picture is adjusted
simultaneously. With SIZE button in PIP mode, sub picture is
adjusted.
1
Press the POSITION button.
Repeatedly press the
D
or
E
or
F
or
G
button until desired posi-
tion is achieved.
The sub picture moves up/down or left/right.
1
2
Win. size
FF GG
U0585Ben_02 12/6/06 11:06 AM Page 33
To Next Page
Loading...
