73
August 2010 42PJ350 Plasma
Y-Drive
Board
P106
c
Y-Scan
Signal
Y
Y
-
-
Drive P106 Connector Diode Mode Testing
Drive P106 Connector Diode Mode Testing
FGFGFGSUS_DN (FG)16-17
0.62VOpen2.63VOC214-15
0.76V3.28V0VDATA12-13
0.62VOpen2.2VOC110-11
0.62VOpen2.8VSTB8-9
0.62VOpen0.86VCLK6-7
FGFGFGSUS_DN (FG)4-5
0.53V2.57V4.9VFG5V2-3
FGFGFGSUS_DN (FG)1
Diode CheckDiode CheckRun LabelPin
Red Lead on FGP106 "Y-Drive" to "Y-SUS" P211
Red Lead Black Lead
Diode Mode Readings taken with all
connectors Disconnected.
DVM in Diode Mode.
Measurements taken from Floating Gnd.
For Floating Ground, use any screw Lug on the far right hand side of the
Y-Drive board except the one just above P106, this is the Y-Scan output.
Y-SUS Board should be
disconnected for the
Diode Mode test.