EasyManuals Logo

LG 49SH7PE User Manual

LG 49SH7PE
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
ENGLISH
52
51. Local Key Operation Lock (Command: t o)
Configures the local key operation settings of the product.
Transmission
[t][o][ ][Set ID][ ][Data][Cr]
Data 00: Unlocks all keys
01: Locks all keys except Power key
02: Locks all keys
Acknowledgment
[o][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be available for all models.
52. Status Check (Command: s v)
Checks the current signal of the product.
Transmission
[s][v][ ][Set ID][ ][Data][ ][FF][Cr]
Data 02: Check whether there is a signal
10: RGB Sensor OK/NG(Check Screen)
Acknowledgment
[v][ ][Set ID][ ][OK/NG][Data][Data1][x]
Data 02 (when a signal is found)
Data 1 00: No signal
01: Signal present
Data 10 (Check Screen)
Data 1 00: Check Screen result NG
07: Check Screen result OK
* When Check Screen is set to Off or not supported, execution results
are rendered "NG."
53. Screen Fault Detection (Command: t z)
Sets the Screen Fault Detection feature.
Transmission
[t][z][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: On
Acknowledgment
[z][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be available for all models.
54. PM Mode (Command: s n, 0c)
Sets the PM mode.
Transmission
[s][n][ ][Set ID][ ][0c][ ][Data][Cr]
Data 00: Power Off
01: Sustain Aspect Ratio
02: Screen Off
03: Screen Off Always
04: Screen Off & Backlight On
Acknowledgment
[n][ ][Set ID][ ][OK/NG][0c][Data][x]
* This feature may not be available for all models.
55. Screen Off Always (Command: j p)
If you activate the Screen Off Always feature, the monitor
enters Screen Off mode regardless of whether or not you have
activated PM mode.
Transmission
[j][p][ ][Set ID][ ][Data][Cr]
Data 00: On (Screen on)
01: Off (Screen off)
* This feature may not be available for all models.
Acknowledgment
[n][ ][Set ID][ ][OK/NG][0d][Data][x]
56. Auto Config. (Command: j u)
Automatically corrects the position and shaking of the picture.
(Works only in RGB-PC input mode.)
Transmission
[j][u][ ][Set ID][ ][Data][Cr]
Data 01: Execute
Acknowledgment
[u][ ][Set ID][ ][OK/NG][Data][x]

Table of Contents

Other manuals for LG 49SH7PE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LG 49SH7PE and is the answer not in the manual?

LG 49SH7PE Specifications

General IconGeneral
BrandLG
Model49SH7PE
CategoryDigital Signage
LanguageEnglish

Related product manuals