To Next Page

To Previous Page

APPENDIX

PROGRAMMING THE REMOTE CONTROL

The provided universal remote control can be programmed to operate most remote-controllable devices.

Note that the remote may not control all models of other brands.

Programming a code into a remote mode

To find out whether your remote control can operate each device without programming, turn on the device

(such as a VCR) and press the corresponding mode button on the remote.

After that, press the

PPOOWWEERR

button. If the device is turned off and it responds properly the remote control

need not be programmed. If not, the remote should be programmed to operate the device. The program-

ming procedures are explained below.

Press the

MMEENNUU

and

MMUUTTEE

button continuously at the same time for two seconds; the currently selected

device button is illuminated.

If you don't press any button for 20 seconds, the light on the mode button will be turned off. In that case,

you have to repeat from step 2.

Enter the appropriate code from the code table on the following pages. When pressing the button, the

light blinks at a time. If the device turned off, the programming is successful.

Press the

MMEENNUU

button to store the code. After blinking twice, this code is stored.

Test the remote control functions to see if the device responds properly. If not, steps 2-5.

LG 50PC5D User Manual

Other manuals for LG 50PC5D