LG
November 2017
55EG9600 (2015 OLED) Power Supply
P201 Connector Voltage Measurements During Tests
23.88V to T-CON
P201 "POWER SUPPLY TEST" 11.90V to T-CON 11.89V to T-CON F101 and F501
Pin Label Test 1 (Jumper A) Test 2 (Jumper B) Test 3 (Jumper C) STBY 170.8V
24 Gnd Gnd Gnd Gnd RUN 394.6V
23 Gnd Gnd Gnd Gnd Diode Check Both Fuses
22 24V 23.72V 24.11V 24.10V OL (Blk on HGnd)
21 24V 23.72V 24.11V 24.10V 0.61V (Red on HGnd)
20 24V 23.72V 24.11V 24.10V
19 24V 23.72V 24.11V 24.10V
18 12V_ON 0V 3.13V 3.13V
17 Gnd Gnd Gnd Gnd
16 Gnd Gnd Gnd Gnd
15 12VM 11.96V 11.93V 11.93V
14 12VM 11.96V 11.93V 11.93V
13 12VM 11.96V 11.93V 11.93V
12 12VM 11.96V 11.93V 11.93V
11 12VM 11.96V 11.93V 11.93V
10 Gnd Gnd Gnd Gnd
9Gnd Gnd Gnd Gnd
8 3.5V_ST 3.55V 3.54V 3.52V
7 3.5V_ST 3.55V 3.54V 3.52V
6Gnd Gnd Gnd Gnd
5 3.5V_ST 3.55V 3.54V 3.52V
4ACD 3.48V 3.44V 3.44V
3DPC 0V 0V 0V
2 DRV-ON 0V 0V 3.13V
1RL-ON 3.13V 3.13V 3.13V
Note: During STBY, with no Jumpers inserted, +3.5V_ST is 3.55V
Note2: Depending on how fresh the batteries are in your 3V Simple Jig, pins 1, 2 and 18 may vary slightly.
Page 08
To Next Page
Loading...
