LG 65EV960H - Page 61

61
206-4322
(Continued from previous page)
3. Refer to the appropriate subsection(s) below to congure the TV’s
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application itself is an additional feature
(see step 4), the appropriate Pro:Centric server conguration
must be completed to enable TV E-Z Installation (conguration
and software/rmware) data downloads and, if congured, the
Pro:Centric application download.
RF Conguration
For TVs in Pass-through Mode or FTG Mode, if the Data Channel is
left at its default value (AUTO), the TV’s Data Channel Auto Search
feature will be enabled. See Installer Menu item 119 DATA CHANNEL
description on page 39 for further information.
To change the Data Channel setting, select/highlight the Data Channel
eld and press the Wheel (OK) button on the Installer Remote. Then,
use the Up/Down arrow keys to select either MANUAL or AUTO from
the drop-down list of options.
When the Data Channel eld is set to “MANUAL,” a data entry eld is
available on the screen, and you can specify the RF channel number
that will be used by the Pro:Centric server as its data channel. The
Data Channel value can be set from 0 (disabled) to 135. * Use the
arrow keys on the Installer Remote to select the Data Channel data
entry eld and press the Wheel (OK) button. You can then use the
number keys on the Installer Remote to direct enter the Data Channel,
or you can use the arrow keys to select the appropriate number(s)
from the pop-up virtual keyboard displayed at the bottom of the screen.
When you are done, select Enter from the virtual keyboard, and then
press the Wheel (OK) button on the Installer Remote.
Note: If the Data Channel has already been set in the Installer Menu
(Installer Menu item 119) or in the EZ-Manager Wizard, the specied
channel will appear in the Data Channel data entry eld. If you change
the Data Channel in this menu, Installer Menu item 119 will now show
the value you entered here.
IP Conguration
Note: If the server IP address and port number or domain name have
already been set in the EZ-Manager Wizard, the specied data will be
reected in the elds displayed.
Note: Setting the Media Type to “IP” automatically sets item 119 DATA
CHANNEL in the Installer Menu to 253. You cannot alter this setting
unless you revert Media Type to “RF.” Also, it is not possible to direct
enter “253” in the Installer Menu.
* PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
Network
Pro:Centric
Media Share
Pre-loaded
Apps
PRO:CENTRIC
Mode
Configuration Only
Update Event
Disable
Media Type
RF
Data Channel
AUTO
^
^
^
^
Note: By default, the Pro:Centric Menu
initially shows RF conguration elds.
When “IP” is selected as the Media Type,
Server Address and either IP Address
and Port Number or Domain Name and
Port Number elds appear on the screen
(in place of the Data Channel eld).
IP Environment Setup (Cont.)
(Continued on next page)