LG 65EV960H - Page 62

62
206-4322
IP Environment Setup (Cont.)
(Continued from previous page)
a) The Server Address eld provides the option to specify the domain name of the Pro:Centric
server instead of the server’s IP address. Select/highlight the Server Address eld and press
the Wheel (OK) button on the Installer Remote. Then, use the Up/Down arrow keys to select
either IP Address or Domain Name from the drop-down list of options for dening the server.
b) Depending on your selection in the previous step, either:
• Enter the Pro:Centric server IP address in the IP Address eld. The IP address must match
the IPv4 multicast address that is set in the Pro:Centric server.
• Enter the Pro:Centric server domain name in the Domain Name eld. Note that in order
for the domain name to be resolved to an IP address, there must be a DNS entry for the
domain name.
For each data entry eld: Use the arrow keys to select the eld and press the Wheel (OK)
button. Then, you can either use the number keys on the Installer Remote to direct enter
data values, or you can use the arrow keys to select the appropriate number(s)/alphanumeric
character(s) from the pop-up virtual keyboard displayed at the bottom of the screen. When
you are done, select Enter from the virtual keyboard, and press the Wheel (OK) button on
the Installer Remote.
c) Enter the Pro:Centric server port number in the Port Number eld. The port number must
match the port number that is set in the Pro:Centric server.
4. Select/highlight the Mode eld and press the Wheel (OK) button on the Installer Remote to
display the drop-down list of Pro:Centric Application Mode options. Then, use the Up/Down
arrow keys to select the appropriate setting—Conguration Only, FLASH, GEM, or HTML.
If the Pro:Centric Application Mode is set to “Conguration Only,” Pro:Centric application data
will not be downloaded.
Note: If the mode has already been set in the Installer Menu (item 098 PRO:CENTRIC) or in
the EZ-Manager Wizard, the specied mode will be reected in this eld. If you change the
mode in this menu, Installer Menu item 098 will now reect the value you selected here.
5. Select/specify the appropriate Update Event setting(s), as required. Based on Update Time
settings, the Wake For Update feature wakes the TV once daily to check for, and if applicable,
download updates from the Pro:Centric server. See Installer Menu item 121 UPDATE TIME HR
description on page 39 for additional information on Wake For Update functionality.
• Select/highlight the Update Event eld and press the Wheel (OK) button on the Installer
Remote. Then, use the Up/Down arrow keys to select either Enable or Disable from the
drop-down list of options. When Update Event is set to “Enable,” an Update Time eld is
displayed on the screen.
• If Update Event is enabled, set the Update Time as required. Use the arrow keys on the
Installer Remote to select/highlight the Update Time eld, and then press the Wheel (OK)
button. Hour, Minute, and Meridiem elds will be displayed. Select each eld in turn and
specify the appropriate Wake For Update time, as desired. Note that the Update Time set
in this menu is based on a 12-hour clock. Ensure the meridiem (AM/PM) specication is set
accordingly.
6. Once all elds are completed as required, use the arrow keys on the Installer Remote to return to
the IP Environment Menu, as necessary, or press BACK/EXIT to exit the IP Environment Menu.