To Next Page

To Previous Page

INSTALLATION

ENGLISH

to the wall by tightening the anchoring screw

all the way.

Plug the power cord into the power outlet.

NOTE

• The charging station can be removed as needed.

To remove it, hold the floor stand dock steady

and pull up on the charging station.

Using Double-Sided Tape to Secure

the Appliance

Use the double-sided tape

to attach the wall

anchoring block

to the charging station.

• Remove the centre section of double-sided

tape before attaching it to the wall

anchoring block.

Attach the second piece of double-sided tape

to the other side of the wall anchoring block to

secure it to the wall.

• Do not use double-sided tape on wallpaper.

Wall-Mounted Installation

For wall-mounted installations, the charging

station must be attached securely to the wall using

the provided(short) wall anchoring screws.

• The detachable nozzle storage cannot be

attached to the charging station in a wall-

mounted installation.

Connect the power adapter to the port on the

back of the charging station.

Drill 2 holes and insert the drywall anchors(if

needed) at least 1 m from the floor and near

enough to easily reach a power outlet.

• Before drilling, make sure that there are no

pipes or electrical wires inside the wall at the

desired location.

• For drywall anchor: use 6.5 mm drill bit

• For concrete or wall stud: use 3 mm drill bit

Questions and Answers:

Need help?

Do you have a question about the LG A9N Series and is the answer not in the manual?

LG A9N Series Specifications

General