3 A
3 A
Ex)
Group Room(Indoor Unit)
No. No.
Group Room(Indoor Unit)
No. No.
Ex)
2.
1. Press 13(program) and 16(set and clear) key more
than 3 second then "Address Setting Mode" starts.
2. Set the address of indoor unit by using "Temperature
setting" key.
■ Range of address : 00 ~ FF
3. After setting address, press 13(program) and 16(set
and clear) key more than 3 second then "Address
Setting Mode" is finished.
1. Address setting Method
1) Press 5(Jet Cool) & 13(Reset) key at the same time more
than 3 seconds then
"Address Setting Mode" starts.
2) Set the address of indoor unit by using
"Temperature setting" key.
■ Range of address : 00 ~ FF
3) After address setting, pressing 1(On/Off) key, address
setting is finished. The address that is set is displayed on a
display window of indoor unit.
* notice : The mothod of display and time is different
according to indoor unit type.
4) If the remote control is reset, normal mode starts.
2. Address Monitoring
1) Press 6(Chaos Swing) & 13(Reset) key at the same time then "Address Monitoring Mode"
starts.
2) At the address monitoring mode, pressing 1(On/Off) key, The address that is set is displayed
on a display window of indoor unit.
* notice : The mothod of display and time is different according to indoor unit type.
3) If the remote control is reset, normal mode starts.
Timer Cancel
Program Week
Hour Min
Holiday
Set/Clr
RESET
ZONE
1234
Operation unit
Humidify
JET
AUTO
AUTO SWING OPERATION
FAN SPEED
Program set
SUB FUNCTION
SET TEMP
Room Temp
HI
MED
LO
Heater
Defrost
Filter
Preheat
Out door
Time
Timer
On
Set no. Time
Off
01 03 05 07 09 11 13 15 17 19 21 23
Plasma
3
10
12
14
15
11
13
18
16
2
1
5
4
6
8
9
7
17
Heat Pump Model
ON
OFF
CANCEL
AUTO CLEAN
SET
1
3
5
4
9
10
16
15
7
2
8
13
14
11
6
12
Flip-up door
(opened)
Signal transmitter
Using Wired Remocon
Using Wireless Remocon
To Next Page
Loading...
Need help?
General
