12
OPERATING INSTRUCTIONS
ENGLISH
Cooling Mode
1 Press | button to turn on the indoor.
2 Press a button to select Cooling
operation mode.
- When canceling operating, press
|
button once more.
3 Adjust the desired temperature by
pressing ( ) buttons.
- If desired temperature is higher than
room temperature, cooling cannot be
conducted.
- Set the temperature lower than the room
temperature
- Setting Temp Range : 18 °C ~ 30 °C.
Auto Dry Function
1 Auto dry function can be setted/released
by manipulating indoor unit button or
remote control.
2 When pressing the | button after setting
the function, evaporator in indoor unit will
be automatically dried as showing counting
00 to 99 on its display panel .
3 After indicating 99 on the display panel,
the unit will be automatically turned off.
* Auto dry function is released at initial
state as standard.
If manipulating indoor unit, press the
|
button and button simultaneously for 3
seconds.
If manipulating remote control for Cooling
Only model, press button.
The indoor unit will respond with beep once
and indicate “SC” on its display panel. Then
Auto dry function will be set.
If manipulating indoor unit, press the
|
button and button simultaneously for 3
seconds.
If manipulating remote control, press
button. The indoor unit will respond with beep
twice and Auto dry function will be removed.
Airflow Setting
We can simply adjust the desired airflow direction.
1 Press | button to turn on the indoor.
2 Press I button and the louvers will swing
up and down.
3 PressI button again to set the horizontal
louver at the desired airflow direction.
1 Press | button to turn on the indoor.
2 Press J button and the louvers will
swing left and right.
3 Press J button again to set the vertical
louver at the desired airflow direction.
<Airflow Setting Table>
For Setting Auto Dry Function
For Releasing Auto Dry Function
Up/Down Airflow Direction Control
Left/Right Airflow Direction Control
NOTE
!
What is 3 minutes delay function?
The reason that cold wind is not coming out
when operating the unit after turning off the
cooling is because of the function to protect
compressor. Cold wind will be coming out
when compressor is operated after 3 minutes.
Symbol Description
I
Up·Down : Vane move from up to
down automatically and continuously
J
Left·Right : Vane move from left to
right automatically and continuously
OPERATING INSTRUCTIONS
Up/Down
Airflow Louver
Left/Right
Airflow Louver
< Type B >
Adjust airflow louvers by hand.
To Next Page
Loading...
