34
Information
Regarding the projector lamp control
• Don’t turn off the projector at least 5 minutes after activating it.
- The frequent On/Off changes may cause the lamp to deteriorate.
• Don’t pull out the power cord while operating the projector or the cooling fan.
- It will shorten the life of the lamp or damage it.
• The life-span of the projector depends on the user's environment and treatment conditions.
• The projector uses a high pressure mercury lamp. Use caution when handling. The lamp can shatter and cause harm.
• If you continue to use the projector after the lamp timer has recommended replacing the lamp, the lamp could shatter and
be difficult and dangerous to remove.
• Do the following if the lamp shatters
- Unplug the projector immediately.
- Let some fresh air in immediately (Ventilation).
- Have service center check the projector for damage and replace the lamp.
- Don’t try to disassemble the projector.
WARNING
To Next Page
Loading...
