SAFETY INSTRUCTIONS
6
ENGLISH
•
Ventilate the product room from time to time when operating it together with a stove,
or heating element etc. Oxygen deficiency can occur and hence harm your health.
• Do not touch refrigerant pipe and water pipe or any internal parts while the unit is
operating or immediately after operation. It can cause a burn or frostbite.
• Do not step on the indoor/outdoor unit and do not put anything on it. It may cause an
injury through dropping of the unit or falling down.
• When the product is not to be used for a long time, disconnect the power supply
plug or turn off the breaker. There is risk of product damage or failure, or unintended
operation.
• Take care to ensure that nobody especially kids could step on or fall onto the
outdoor unit. This could result in personal injury and product damage.
• Take care to ensure that power cable could not be pulled out or damaged during
operation. There is risk of fire or electric shock.
• Do not place anything on the power cable. There is risk of fire or electric shock.
• When flammable gas leaks, turn off the gas and open a window for ventilation
before turning on the product. Do not use the telephone or turn switches on or off.
There is risk of explosion or fire.
• Make sure to ventilate sufficiently when this air conditioner and a heating appliance
such as a heater are used simultaneously. Failure to do so may result in fire, serious
injury, or product failure.
• Periodic ( more than once/year ) cleaning of the dust or salt particles stuck on the
heat exchanger by using water.
• Do not use means to accelerate the defrosting process or to clean, other than those
recommended by the manufacturer.
• Do not pierce or burn refrigerant cycle part.
• Be aware that refrigerants may not contain an odour.
• When mechanical connectors are reused indoors, sealing parts shall be renewed.
(for R32)
• When flared joints are reused indoors, the flare part shall be re-fabricated. (for R32)
CAUTION
Installation
• Two or more people must lift and transport the product. Avoid personal injury.
• Do not install the product where it will be exposed to sea wind (salt spray) directly. It
may cause corrosion on the product.
• Install the drain hose to ensure that the condensed water is drained away properly.
A bad connection may cause water leakage.
• Keep level even when installing the product. To avoid vibration or noise.
• Do not install the product where the noise or hot air from the outdoor unit could
damage or disturb the neighborhoods. It may cause a problem for your neighbors
and hence dispute.
!
To Next Page
Loading...
Need help?
General
