LG D2542P-PN - Volume Settings (Only Supported in HDMI); SUPER ENERGY SAVING Settings

15
ENG
ENGLISH
CUSTOMIZING SETTINGS
SUPER ENERGY SAVING Settings
1
Press any button on the front of the Monitor set to
display the MONITOR SETUP OSD menu.
2
Press the MENU button to display the options in the
OSD menu.
3
Select SUPER ENERGY SAVING by pressing the
buttons on the front of the Monitor set and set the
options.
4
Select EXIT to leave the OSD menu.
To return to the upper menu or set other menu items,
use the up arrow ( ) button.
Volume Settings (Only supported in HDMI)
1
Press any button on the front of the Monitor set to display the
MONITOR SETUP OSD menu.
2
Press the VOLUME button to display the options in the OSD
menu.
3
Set the options by pressing the buttons on the front of the
Monitor set.
4
Select EXIT to leave the OSD menu.
To return to the upper menu or set other menu items, use the up
arrow ( ) button.
The available picture SUPER ENERGY SAVING settings are described below.
Menu Description
ON Enables SUPER ENERGY SAVING you can save energy with this energy-efficient function.
OFF Disables SUPER ENERGY SAVING.
RESET Resets the values of total energy consumption reduction and CO2 emission reduction estimates.
OK
ON OFF RESET
TOTAL POWER REDUCTION: 20 W
TOTAL CO2 REDUCTION: 16 g
SUPER
SAVING
: 5 W/h
LED
SAVING
: 12 W/h
SUPER ENERGY SAVING
VOLUME
EXIT
50
y
TOTAL POWER REDUCTION: How much power is saved while using the monitor.
y
TOTAL CO2 REDUCTION: Change the TOTAL POWER REDUCTION to CO2.
y
SAVING DATA(W/h)
546 mm(22 inch) 584 mm (23 inch) 634 mm(25 inch)
SUPER SAVING 4 W/h 5 W/h 5 W/h
LED SAVING 15 W/h 12 W/h 12 W/h
y
Saving Data depends on the Panel. So,those values should be different from each panel and panel
vendor.
y
LG calculated these values by using “broadcast video signal”.
y
LED Saving refers to how much power can be saved using a WLED Panel instead of CCFL panel.
y
SUPER SAVING refers to how much power can be saved using the SUPER ENERGY SAVING
function.
NOTE
EXIT