37
PROGRAMMING MODE - TEST MODE
Entering set up mode.
You will see LqC1
Button Display
Press the
75°C HOT
or the
60°C NORMAL
button until appears in the
display.
Press the
START
button.
Press the
75°C HOT
button until appears in the display.
Press the
START
button, then tub clean reset is done.
is displayed.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• OPL type - Push the 90°C MEDICAL button twice.
6 TUB CLEAN -
To clean up the tub, please run the TUB CLEAN cycle.
To Next Page
Loading...
