VALVE (
PRE-WASH)
VALVE
(NORMAL-WASH)
1
Disconnect the wiring connector.
1
2
3
2
Remove the valve by two screws of the valve
holder.
• Rating : 220/240V 50/60Hz
• Resistant : 3.5~4.5kΩ
When reconnecting the connector
1
Open the door completely.
2
Remove the three screws from the hinge.
When removing the Door Assembly, it is
necessary to hold the Bracket that is inner of
the Cabinet Cover.
First, prepare a bucket to put in the remained
water.
Pull it out from hose.
GRAY/ BLACK-BLACK
WHITE
VALVE
(DRY)
YELLOW/ BLACK-BLACK
/ BLACK-BLACK
INLET VALVE
DOOR
Removing method of remained water
CAP(REMAING HOSE)
1
2
3
To Next Page
Loading...
