①
Dry Valve Black-Black/Yellow
Black-Black/Gray
Black-Black/White
Black-Black/Purple
Black-Black/Blue
Pre Inlet Valve
Main Inlet Valve
Steam Valve
Filter Clean Valve
②
③
④
1
4
5
3
2
45
1
Disconnect the wiring connector.
2
Remove the valve by two screws of the valve
holder.
• Rating : 220/240V 50/60Hz
• Resistant : 3.5~4.5kΩ
When reconnecting the connector
1
Open the door completely.
2
Remove the three screws from the hinge.
When removing the Door Assembly, it is
necessary to hold the Bracket that is inner of
the Cabinet Cover.
First, prepare a bucket to put in the remained
water.
Pull it out from hose.
INLET VALVE
DOOR
Removing method of remained water
CAP(REMAING HOSE)
⑤
To Next Page
Loading...
