Operating26
Operating
3
Using your player as an alarm
clock
1. Turn the unit on.
2. Press and hold ALARM.
3. Press
C/V
on the remote control to
change the hours and minutes and Press
SET/RDS, DEMO on the unit or RDS/SET on
the remote control to save.
4. Press
C/V
on the unit to select function
and press SET to save.
5. Press
C/V
on the remote control to
change the volume and Press SET/RDS, DEMO
on the unit or RDS/SET on the remote control
to save. The clock icon “
(
“ shows that the
alarm is set.
y
If you set the clock time, you can check the
time by pressing CLOCK even when the
player is turned o.
y
If you set the clock time and alarm, you
can check the alarm icon “
(
“ by pressing
CLOCK even when the player is turned o.
y
If you set the clock time and alarm, you
can check the alarm icon “
(
“ and setting
informaiton by pressing ALARM even when
the unit is turned o.
y
Press ALARM, you can selects a ALARM on
/ o mode.
y
If the alarm rings with USB cable connected
to USB port, the function switches to tuner
function. (Depending on the type of device,
this may not be available.)
,
Note
Sleep Timer Setting
Press SLEEP repeatedly to select delay time
between 10 and 180 minutes. After delay time, the
unit will turn o. (You can see the following order,
180 -> 150 ->120 -> 90 -> 80 -> 70 -> 60 -> 50 ->
40 -> 30 -> 20 -> 10)
To cancel the sleep function, press SLEEP
repeatedly until the display window get bright.
y
Press SLEEP. The remaining time appears in
the display window.
y
Sleep function will work after dimmer
function.
,
Note
Dimmer
Press SLEEP once. The display window will
be darkened by half. To cancel it, press SLEEP
repeatedly until the display window get bright.
Auto Power Down
This unit will power o itself to save electric
consumption in the case main unit is not
connected to external device and is not used for 20
minutes.
This unit will power o after six hours when
connected to a device using an analog input.