Adjusting the general settings - more you can do
Adjusting the language settings
OSD (Menu Language) – Select a language for the Setup menu and on-screen
display.
Disc Audio/ Disc Subtitle/ Disc Menu – Select a language for the Disc Audio/ Disc
Subtitle/ Disc Menu.
[Original] Refers to the original language in which the disc was recorded.
[Other] To select another language, press number buttons then
ENTER to enter the corresponding 4-digit number according
to the language code list in the reference chapter (Page 17). If
you make a mistake before pressing ENTER, press CLEAR.
[Off]
(for Disc
Subtitle)
Turn off Subtitle.
Adjusting the display settings
TV Aspect – Select which screen aspect to use based on the shape of your TV
screen.
[4:3] Select when a standard 4:3 TV is connected.
[16:9] Select when a 16:9 wide TV is connected.
Display Mode – If you selected 4:3, you’ll need to dene how you would like wide
screen programs and lms to be displayed on your TV screen.
[Letterbox] This displays a wide screen picture with black bands at the top and
bottom of the screen.
[Panscan] This lls the entire 4:3 screen, cropping the picture as necessary.
Adjusting the audio settings
DRC (Dynamic Range Control) – Make the sound clear when the volume is
turned down (Dolby Digital only). Set to [On] for this effect.
Vocal – Select [On] to mix karaoke channels into normal stereo. This function is
effective for multi-channel karaoke DVDs only.
HD AV Sync – Sometimes Digital TV encounters a delay between picture and
sound. If this happens you can compensate by setting a delay on the sound so that it
effectively ‘waits’ for the picture to arrive: this is called HD AV Sync. Use
U u
(on the
remote control) to scroll up and down through the delay amount, which you can set
at anything between 0 and 300m sec.
Adjusting the lock settings
To access the lock options, you must enter the 4-digit password. If you have not yet
entered a password you are prompted to do so.
1 Enter a 4-digit password then press ENTER.
2 Enter it again then press ENTER to verify. If you make a mistake while entering
number, press CLEAR then correct it.
Area Code – Select a code for a geographic area as the playback rating level. This
determines which area’s standards are used to rate DVDs controlled by the parental
lock. See the Area Codes on page 17.
Rating – Select a rating level. The lower the level, the stricter the rating. Select
[Unlock] to deactivate the rating.
Password – Sets or changes the password for lock settings.
[New] Enter a new 4-digit password using the numerical buttons then
press ENTER. Enter the password again to conrm.
[Change] Enter the new password twice after entering the current password.
If you forget your password you can reset it.
1 Remove the disc in the unit.
2 Press SETUP to display the Setup menu. Input ‘210499’ and press ENTER. The
password has now been cleared.
Adjusting the general settings
ON REMOTE
1 Display setup menu
SETUP
2 Select a desired option on the rst level
Uu
3 Move to the second level
i
4 Select a desired option on the second level
Uu
5 Move to the third level
i
6 Change the setting
Uu
,
ENTER
To Next Page
Loading...
