- 16 -
Please check Manufacturer Name、Vendor Assigned Code、 Monitor Name、 Serial Number：*****[????????
******] (it must be the same as Bar Code)、 Week of Manufacture：**、Year of Manufacture：****、Check
sum：** (It must be the same as the last byte of data table, as follows picture shows). Above of all must
be right, then if it shows the green “PASS”, it means record succeeds ,the red “Fail” means record fails;
then check the power supply and signal line, and ensure they are connected well ,then do DDC record
again from the third step.
Fig.2
http://www.wjel.net
To Next Page
Loading...
