48
Water Filter
Push fit connector type
*1
1
Remove the screw cap.
2
Pull the pipe out from the water fitler.
3
Push the pipe into the water fitler,
making sure the end is fully sealed.
4
Insert the screw cap until the colored
line in the water filter is no longer
visible.
5
Press and hold the
Water Filter
button for three seconds. That resets
the
Replacement Filter
icon. The
new water filter has been activated.
6
Dispense water for approximately 5
minutes to remove trapped air and
contaminants from the system.
To Next Page
Loading...
