- 114 -
LGE Internal Use Only Copyright © 2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
5. DOWNLOAD & S/W UPGRADE
1. Connect cable within the device.
2. Windows will pop-up Found new hardware wizard and detect the new usb device.
3. Check “Install the software automatically (Recommended)” button,
install driver for the device. (or set specific location.)
4. In case of Infineon
In case of Neptune, “LGE GSM Device OMAPV1030” will be installed.
5. If you have several usb ports for usb download, you have to repeat
installation from No. 1 to No. 3 for each the usb port.
Eg. In case of Infineon, “Flash Loader utility” will be installed as shown below.
1. Connect cable within the device.
2. Windows will pop-up Found new hardware wizard and detect the new usb device.
3. Check “Install the software automatically (Recommended)” button,
install driver for the device. (or set specific location.)
4. In case of Infineon
In case of Neptune, “LGE GSM Device OMAPV1030” will be installed.
5. If you have several usb ports for usb download, you have to repeat
installation from No. 1 to No. 3 for each the usb port.
Eg. In case of Infineon, “Flash Loader utility” will be installed as shown below.
1. Connect cable within the device.
2. Windows will pop-up Found new hardware wizard and detect the new usb device.
3. Check “Install the software automatically (Recommended)” button,
install driver for the device. (or set specific location.)
4. In case of Infineon
In case of Neptune, “LGE GSM Device OMAPV1030” will be installed.
5. If you have several usb ports for usb download, you have to repeat
installation from No. 1 to No. 3 for each the usb port.
Eg. In case of Infineon, “Flash Loader utility” will be installed as shown below.
To Next Page
Loading...
