8
DISASSEMBLY
#1 #2
#3
#4
#6#5
Put a soft cushion on the desk and lay the stand on
its side so that the base is accessible.
Unscrew the 4 screws on the hinge to separate the
hinge neck ass’y
.
Twist the stand assy until “click” , then take out the
stand assy into the product in the
correct direction as shown in picture.
Pry the hinge cover by flat-tip screw driver or jig and
be careful to prevent from scratching the hinge
cover.
Pull up the front cover side by side(4 sides) and take
away the front cover
Turn over the set and pull up the cabinet to separate
the control cable, then take away the back cover
To Next Page
Loading...
