16
CAR CD/MP3/WMA Receiver
Troubleshooting
Symptom Cause Correction
Power doesn’t turn on /
The unit doesn’t operate.
No sound is heard / The vol-
ume level will not rise.
There’s audio skipping.
The playback is not possible.
Radio stations cannot be
tuned in.
iPod does not work.
The unit does not operate
correctly even when the
appropriate remote
control buttons are pressed.
Leads and connectors are not properly.
The fuse is blown.
Noise and other factors are causing the built-
in microprocessor to operate incorrectly.
Cables are not connected correctly.
This unit is not firmly secured.
The disc is dirty.
The loaded disc is of a type this unit cannot
play.
The signal strength of the stations is too
weak(when tuning in with automatic tuning.)
No station has been preset or preset stations
have been cleared(when tuning by scanning
preset stations.)
Check whether iPod is connected to the unit
correctly.
Battery power is low.
Confirm once more that all connections are
correct.
Rectify the problem that caused the fuse to
blow, and then replace it. Be very sure to
install the correct fuse with the same rate.
Turn the unit off and then on.
Connect the cables correctly.
Secure this unit firmly.
Clean the disc.
Check what type the disc.
Tune in the stations manually.
Preset the stations.(Refer to the page 12)
Connect it to the unit correctly.
Load a new battery.
General
CD
Radio
iPod
Remote
control
To Next Page
Loading...
Need help?
General
