•
If the height of the opening is below
850mm, you can remove the top table by
unscrewing the 2 screws.
(Two from rear)
CAUTION
1. Lay the dishwasher on its back.
2. Adjust the legs to the required height
as shown in below figure.
1. Before sliding the dishwasher into the
installation opening, all necessary height
and height adjustments should be made
using a spanner.
2. Slide the dishwasher into the cabinet,
opening carefully. Make sure that the drain
hose inside the cabinet is not kinked or
stretched.
Adjust leg
8
INSTALLATION INSTRUCTIONS
Preparing the dishwasher for
installation
Installing the dishwasher in its
location
(use an open end or adjustable spanner.)
27mm or
1-1/16 inch
To Next Page
Loading...
