Connections and settings 35
Daylight Saving End: Select the Daylight Saving end
time.
Caution:
If you change the time setup, warning message will be dis-
played. For example, if you delay the time by 10 minutes,
the overlapped 10minutes data can be deleted.
NTP
NTP: Set to ON when using the NTP (Network Time
Protocol) server for time adjustment. If the NTP is set to
OFF, the time settings should be entered manually and
the [Server], [Private Time Server], [Sync. Interval] and
[NTP Test] options are not set.
Server: Select your time server. For most cases select
public. The DVR will obtain the average time among 5
public servers (time.nist.gov, time-a.nist.gov, time-b.nist.
gov, ntp.nasa.gov, clock.isc.org).
Private Time Server: Enter the private time server's IP
address or host name using the virtual keyboard.
Sync. Interval: You can set synchronized intervals with
the NTP time server to 1 day, 1 hour, 1 month and 1
week.
NTP Test: Select [NTP Test] to test the NTP server.
•
•
•
•
•
•
Buzzer
Button
ON: Makes a sound when using the buttons.
OFF: Turns off the button beep.
Sensor
ON: Makes a sound when a sensor occurs.
OFF: Turns off the sensor buzzer.
Motion
ON: Makes a sound when a motion is detected.
OFF: Turns off the motion buzzer.
System
ON: Makes a sound when the HDD has a bad sector.
OFF: Turns off the system buzzer.
Note:
The sensor and motion buzzer have low sound on this unit.
If you want to make a loud sound, connect an external
alarming device to the RELAY-OUT terminals (ex. Siren).
•
-
-
•
-
-
•
-
-
•
-
-
To Next Page
